BAUMFOLDER FAQ’s

If you have a question not addressed below please call toll-free, 1-800-543-6107 and direct your questions to our technical services department. Or, if you prefer, e-mail us at techservice@baumfolder.com

Older Folders and Cutters….

  1. If the counter is not working and the counters are one of the following: BC-100, BC-200, BC-300, DATATRAC III, DATATRAC I, OR DATATRAC IV
    Contact: P.D.I. Systems; Indianapolis, IN; Phone# (317)247-6040.
  2. For Lawson-Baum Cutters please contact:
    Lawson Service Phone# (800)265-2702.
  3. How do I set the Feed Caliper?
  4. How do I adjust the pile height?
  5. I am Rebuilding my folder, how do I set the Fold Rolls and Fold Plates to the fold rolls?…For the following Models: Mark I, Ponys, Jr. Jet, 017, 400, 500, O&M, and Futura Series directions are here….For the Models: Mark II, 200 and 700 Series directions are here.

BAUM 20, BAUM 18, & BAUM 15 Folders….

  1. I have FC Relay Messages - Check the following fuses. F1 & F2 on the circuit board.
  2. I have CLR Stop Message - Check the fuses F8 & F9 on the circuit board.
  3. Overrun Message, Service Bulletin
  4. Inch/Metric - Length will not go under 150 - Length is now in metric. How do I change this?
  5. How Do I Install Static Eliminator Bars? The answer is here.

714 Table-Top Folders….

  1. On 714A or B with Air, I just changed tires on sucker wheel, Now I’m having trouble feeding. What do I need to do?
  2. On 714 the drive motor keeps shutting off. Whats wrong?
  3. How do we set-up to Score or Perf?
  4. I run a lot of ‘Z’ fold work and I have sheets jamming and missing the number 1 fold plate. What can I do?
  5. I am getting a wrinkle on the trailing edge of my paper that runs perpendicular to the fold. What is wrong?
  6. On my 714MP I am always getting the error message ‘folder jam’. What is wrong?

BaumPrint 18 Press….

  1. On the BaumPrint18 why is blanket packing so important?
Back to Top ↑