CF20 Folder
Innovation in folding technology
Features
- Hang-on delivery stacker with independent drive and speed control
- Independent electrical power box with capability to add more optional features
- Infeed crosscarrier table with angled roller design
- Adjustable height marble holder to allow for single sheet to mulitple sheet thicknesses
- Sound covers over upper buckle plates are standard
- Four fold plate positions with two operating plates and two stationary deflectors
- Jam detection at the exit end of the folder using electro-mechanical switch
- New non-marking, flip deflectors buckle plate technology that eliminates the need to pull plates up to switch from open to deflect positions.
- Large solid urethane folding rollers to handle heavier weight stocks and resist curl
- Mobility of folder with wheels and locking brake
Recommended Optional Productivity Enhancements
- Remote Control
- Additional Fold Plates
- Marble Controller
- Perforating kits
- Slitting kits
CF20 Folder
Designed to operate independently behind most impact or rotary creasing machines in tandem or at a right angle to the exit of the creasing or scoring machine. The fully adjustable height design allows the CF20 to accept sheets from low to very hight entry heights to adapt to multiple machines.
Specifications:
- Minimum sheet width: 3.94 in. (10.0cm)
- Maximum sheet lenth for tandem in-line feed: 31.0 in. (78cm)
- Maximum sheet lenth for right angle feeding: 20.5 in. (52.07cm)
- Minimum sheet length: 5.94 in. (15.09cm)
- Minimum fold length: 3.0 in. (7.62cm)
- Minimum stock weight: 16# bond (60gsm)
- Maximum stock weight: 385gsm **
- Fold Roller diameter: 2.75 in (69.9mm)
** Results are based upon stock being pre-scored, creased or perforated on the fold line. results of heavy weight stocks without pre-scoring, creasing or perforating on the fold line will vary.
Contact your sales representative to learn more about this product.